Performance air filter from Pipercross for mk 1 V7 models. 30% more airflow than a standard filter, supplied pre-oiled and ready for lifetime use on your bike. A great way to improve performance on your modern V7 mk 1

 1 in stock

AP8104242

Upper choke cable

We advise you to measure your existing cable before ordering in case you have a non standard set up.

 This part is available by special order, request a quote

 31132881 GU31132881 31 13 28 81
 3113 2881 3113.2881 31.13.28.81

Closing throttle cable for models with ZGULMH00 chassis prefix

We advise you to measure your existing cable before ordering in case you have a non standard set up

 This part is available by special order, request a quote

 883263 MG883263

Upper choke cable

We advise you to measure your existing cable before ordering in case you have a non standard set up.

 Availability varies on this part, check availability

 31132865 GU31132865 31 13 28 65
 3113 2865 3113.2865 31.13.28.65

Rubber gasket for sealing fuel pump to fuel tank

 This part is available by special order, request a quote

 01107490 GU01107490 01 10 74 90
 0110 7490 0110.7490 01.10.74.90

Also fits Aprilia Dordsoduro (2008-2015), Aprilia Shiver (2007-)

Complete choke cable

One required

 This part is available by special order, request a quote

 32137010 GU32137010 32 13 70 10
 3213 7010 3213.7010 32.13.70.10

K&N high performance air filter, flat paper cartridge type for single throttle body models

• High Air Flow with Excellent Filtration
• Designed to Increase Horsepower and Acceleration
• Washable and Reusable
• Will NOT Void Vehicle Warranty
• Lasts up to 50,000 miles before cleaning is required depending on driving conditions
• K&N Million Mile Limited Warranty�
• Emissions Legal
• Economical, a K&N Air Filter Will Last the Life of Your Bike
• Works with Original Equipment Manufacturer Vehicle Electronics
• Easy High Performance Add-on
• Environmentally Friendly

 This part is due back in stock soon, call 01484 841395 to reserve yours

AP8104924

TPS for throttle body on 2 valve/cylinder models

 Order now and we will post your order within 7 days.

 05112830 GU05112830 05 11 28 30
 0511 2830 0511.2830 05.11.28.30

The BoosterPlug is an effective and cost efficient way to cure the fuelling problems common to all modern fuel injected Guzzi's.
Plugging directly into the wiring harness using original connectors, with no cutting or splicing required, installation takes less than ten minutes.

The BoosterPlug features a unique technology to provide your bike with a controlled fuel enrichment in all ambient temperature situations. No other Plug and Play device does this. A richer mixture is provided only when needed i.e at low RPMs and when accelerating. On open roads at a constant speed the Boosterplug sits idle to keep fuel consumption low.
Make your bike run as it should have done from the factory!

• Improved and gentler throttle action when opening and closing throttle
• Richer mixture when opening the throttle improves acceleration
• Booster plug removes the uneven low speed running that is typical for modern lean burn engines
• Stronger and more consistent at idle.
• Reduced backfiring with aftermarket exhausts on engine braking
• Lifetime warranty

 This part is due back in stock soon, call 01484 841395 to reserve yours

HIgh performance aluminium velocity stack for airbox to throttle body union on single throttle body models. This velocity stack replaces the standard part with an aluminium part that protrudes into the airbox. Through careful design it improves the engine response by providing an increased volume of less turbulent air to the throttle body. No modifications are required to fit this velocity stack but you should see a torque increase of around 6% at 2500 RPM and 3% increase in power at 6500 RPM

This manifold is suitable for EURO 4 and 5 models, manufactured on the shores of Lake Como. Developed for optimum power and torque on Mistral's rolling road. For best results combine with a performance air filter - SIA10434.

Simple to fit, installation time is less than 30 minutes and the battery does not need to be disconnected.

 This part is available by special order, request a quote